![]() ![]() Once it is connected directly, try to go through this procedure again.Īnother option is to try a quick zero-fill from the main menu and then to try a "C - Set Capacity" again. If the drive is on a controller card then it is possible that the set drive size command may not work. Make sure the drive is connected directly to the motherboard and not to a third-party controller card. If a message in red displays, then an error occurred. Remove the SeaTools diskette/CD, power off the computer for a few seconds, then reboot and check the capacity of the drive again in the BIOS. I also ran a full CHKDSK for good measure. It took less than a second to fix, and since then the Event viewer errors went away, and subsequent short DST tests have passed. Mouse was shown as installed as PS/2 during the FreeDOS boot. I booted to Seatools, ran the full drive self test, which identified a few dozen bad blocks, and offered to fix them. Symptoms: The SeaTools bootable CD booted ok, and the initial SeaTools interface showed up with a licence acceptance screen. If you get an OK message in white in the middle of the screen, then the process was successful. This happened when trying to check a Seagate hard disk on an Acer TravelMate 5512 with SeaTools for DOS v2.20. Click the "R - Reset to Maximum" button.Click "C - Set Capacity" at the top of the screen.If this is not the current drive, click the "D - Drive" button in the upper left until you see the drive you want to test displayed in the middle of the screen. The model number of the drive currently selected is displayed here. You can see what device is selected by looking in the middle of the screen. Look at the bottom portion of the window to see what drives are listed and what device number they are. Now choose the drive for which to set the size.Click "I agree" to the license agreement. ![]() Once booted from the SeaTools for DOS diskette or CD, the computer should display a screen with a license agreement. 137GB or 32GB) and it is a computer that should support a drive that large, then this would be a time to set the drive size. For example, if the drive is showing up as a smaller capacity in the BIOS (i.e. Sometimes it is necessary to use the SeaTools for DOS software to get the drive back to its native capacity. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |